How to Replace Battery in 2019 Ford Explorer Key Fob
Replacing the battery in your 2019 Ford Explorer key fob is a straightforward process that can be done at home with a few simple tools. This article will guide you through the steps to safely and effectively replace the battery, ensuring that your key fob remains functional and reliable.
Tools and Materials Needed:
Before beginning the replacement process, gather the following tools and materials:
– Replacement battery (CR2032)
– Small flathead screwdriver
– Plastic pry tool or needle-nose pliers
– Soft cloth or paper towel
Step 1: Locate the Battery Compartment
Start by locating the battery compartment on your 2019 Ford Explorer key fob. The battery compartment is typically found on the back of the key fob, close to the buttons. Look for a small tab or clip that may be holding the back cover in place.
Step 2: Remove the Back Cover
Using the flathead screwdriver, gently pry the back cover away from the key fob. Be careful not to apply too much force, as this may damage the plastic. Once the cover is loose, use your fingers to remove it completely.
Step 3: Remove the Old Battery
With the back cover removed, you will see the old battery. Use the flathead screwdriver to carefully lift the battery out of the compartment. Be sure to hold the battery by its edges to avoid damaging the contacts.
Step 4: Insert the New Battery
Take the new CR2032 battery and insert it into the compartment with the positive (+) side facing up. Make sure the battery is properly seated and the contacts are making good contact with the battery.
Step 5: Reassemble the Key Fob
Place the back cover back onto the key fob, ensuring that it is properly aligned with the compartment. Gently press the cover down until it clicks into place.
Step 6: Test the Key Fob
Once the key fob is reassembled, test it to ensure that the new battery is working correctly. Press the buttons on the key fob to see if the car responds to the commands.
Conclusion
Replacing the battery in your 2019 Ford Explorer key fob is a simple and cost-effective way to keep your key fob functioning properly. By following these steps, you can easily perform the replacement yourself and avoid the expense of taking it to a professional. Always use the correct battery type and ensure a secure fit to prevent any potential issues with your key fob.
